Frequency Check; Reset Camera Settings; Swap Out System Parts; Last Resort - lynx System Developers RadioLynx Troubleshooting Manual

Frequency Check

1) Remove the black cap on the DecRadio and the right most black cap on the back of the EncRadio.
2) Verify that the 4 dipswitches (frequency setting) match for the two units.
3) Some areas may require changing the frequency of the units to avoid wireless interference.

Reset Camera Settings

System Information...
1) Go to Help |
2) Click Delete camera default file
3) Click Ok and restart FinishLynx.
4) This resets all settings. Follow the

Swap Out System Parts

1) Swap out one part at a time to utilize process of elimination.
2) Test the DecRadio on another camera system that is currently working.
3) Test the EncRadio on another camera system that is currently working.
4) Continue swapping parts until the fault is detected.

Last Resort

If you have tried all of the above steps but are still having problems with your RadioLynx units, stop and take a
deep breath. Remember, you can still time events using the wired start cables that shipped with your system.
Send in your RadioLynx units for diagnosis and repair by following our RMA process:
https://finishlynx.com/support/repair-rma-portal/
Support: support@finishlynx.com
Phone: (978) 556-9780
Address: 179 Ward Hill Avenue
Haverhill, MA 01835
This completes the RadioLynx Troubleshooting Guide.
NOTES:
RadioLynx Wireless Start
support@finishlynx.com
(.cdf).
RadioLynx QSG from the beginning.
2 of 2
Lynx System Developers, Inc.
www.finishlynx.com