Command (B0 H ) - Seagate Medalist Pro Series Product Manual

Medalist Pro 2520/2160 Product Manual, Rev. C
The Write Relocation, in addition to write cache, can be disabled by using
the Set Feature command Disable Write Cache, feature value 82
feature is not implemented for the Write Long command.
Write Relocation and write cache are both disabled using value 82
These features are mutually exclusive.
3.2.6 S.M.A.R.T. command (B0
Self-Monitoring, Analysis and Reporting Technology (S.M.A.R.T.) is an
emerging technology that provides near-term failure prediction for disc
drives. When S.M.A.R.T. is enabled, the Seagate drive monitors prede-
termined attributes within itself that are susceptible to degradation over
time. S.M.A.R.T. makes a status report available so that the host can
prompt the user to back up the drive if self-monitoring determines that a
failure is likely. Not all failures are predictable. S.M.A.R.T. predictability
is limited to only those attributes the drive can monitor.
The S.M.A.R.T. feature is disabled at the factory. You must have a BIOS,
software driver or application software that supports S.M.A.R.T. to
enable this feature. The table below shows the S.M.A.R.T. command
codes the Seagate drives use.
Note. To implement a S.M.A.R.T. command, the host must write the
value 0x4F to Cylinder_lo register and the value 0xC2 to the
Cylinder_hi register at the same time it writes the S.M.A.R.T.
command code to the Features register. If these values are not
included with the command code, the command will be aborted
and 0x04 (abort) will be written to the Error register.
Command code Feature description
Enable/disable attribute autosave
D2
H
Enable operation
D8
H
Disable operation
D9
H
Return S.M.A.R.T. status
DA
H
H.
)
H
35
This
.
H