Ryobi ONE+ PBLSV717 Operator's Manual page 6

USING THE FLOOR NOZZLE
See Figures 4, page 9
The floor nozzle can connect directly to the vacuum for
cleaning upholstery and stairs or attach with the extension
wand for normal floor vacuuming.
NOTE: When not in use, always store the unit on the wall
mount or lie flat to prevent falling over. Never stand alone in
the upright position. There is a lip located on the handle of
the vacuum that allows it to catch on a surface to prevent
it from slipping.
To connect:
 Switch off unit and remove the battery pack.
 Align the pins on the floor nozzle with the receptacle in
the stick vacuum or extension wand.
 Press together until it clicks into place.
 Replace battery pack.
To remove:
 Switch off unit and remove the battery pack.
 Depress locking tab and pull to remove.
ATTACHING AND REMOVING THE EXTENSION
WAND AND ACCESSORY TOOLS
See Figure 5, page 9
The extension wand and accessory tools can be used together
or separately for a variety of cleaning tasks.
To connect:
 Switch off unit and remove the battery pack.
 For the extension wand, align the pins on the extension
wand with the receptacle in the stick vacuum.
 Press together until it clicks into place.
 For accessory tools, insert the tool into the outlet of the
stick vacuum or the extension wand.
 Press together until it fits securely.
 Replace battery pack.
To remove:
 Switch off unit and remove the battery pack.
 Depress locking tab and pull to remove.
OPERATION
REMOVING/EMPTYING/REATTACHING THE
DUST BOWL
See Figures 6 - 8, page 9.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To empty:
 Remove the battery pack.
 Push the release button located on the front of the
vacuum. Pull the dust bowl down and out.
 Hold unit over waste receptacle.
 Press the locking tab on bottom of bowl to release spring
loaded door.
 Shake lightly or tap sides to dislodge debris.
 Close door, pressing firmly until lock button engages.
To remove:
 Remove the battery pack.
 Push the release button located on the front of the
vacuum. Pull the dust bowl down and out.
To reattach:
 Position the two sections as shown.
 Align the slot on the bottom of dust bowl with the tab on
the bottom of motor housing.
NOTE: Make sure tab and slot are aligned correctly before
securing the dust bowl.
 Snap the two sections together.
REMOVING BLOCKAGES AND CLEANING
THE FLOOR NOZZLE
See Figure 9, page 10.
Obstructions in the floor nozzle may activate the overload
protection sensor and must be removed. The floor nozzle
will stop and the light on the floor nozzle illuminates red.
To reset:
 Remove the battery pack.
 Remove the floor nozzle assembly from the wand or stick
vacuum base and clear any obstructions with a blunt
object.
 Wait at least 1 minute before reattaching the assembly.
For use with PBLBB716 or PBLBB717
Floor Nozzle or A32BR01 Mini Beater Bar.
6 — English