Table of Contents
Advertisement
Operating Basics
Points to note about the fingerprint sensor
Failure to follow these guidelines might result in (1) damage to the sensor
or cause sensor failure, (2) fingerprint recognition problems, or lower
fingerprint rec-ognition success rate.
■
Do not scratch or poke the sensor with your nails or any hard or sharp
objects.
■
Do not press too hard on the sensor.
■
Do not touch the sensor with a wet finger or any wet objects. Keep the
sensor surface dry and free of water vapor.
■
Do not touch the sensor with a soiled finger. Minute foreign particles on
a soiled or dirty finger may scratch the sensor.
■
Do not paste stickers or write on the sensor.
■
Do not touch the sensor with a finger or any object with built-up static
electricity.
Observe the following before you place your finger on the sensor.
■
Wash and dry your hands thoroughly.
■
Remove static electricity from your fingers by touching any metal
surface. Static electricity is a common cause of sensor failures,
especially when the weather is dry.
■
Clean the sensor with a lint-free cloth. Do not use detergent to clean the
sensor.
■
Avoid the following finger conditions for enrollment or recognition as
they may result in fingerprint enrollment errors or a drop in the
fingerprint recognition success rate.
■
■
■
■
■
Observe the following to improve the fingerprint recognition success rate.
■
Enroll two or more fingers.
■
Enroll additional fingers if recognition failure occurs often with enrolled
fingers.
■
Check your finger condition. Changed conditions, such as injured,
rough, extremely dry, wet, soiled, dirty, oily, soaked and swollen fingers,
may lower the recognition success rate. Also, if the fingerprint is worn
down or the finger becomes thinner or fatter, the recognition success
rate may be lowered.
4-4
All manuals and user guides at all-guides.com
Soaked or swollen finger (e.g. after taking bath)
Injured finger
Wet finger
Soiled or oily finger
Extremely dry skin condition
User's Manual
Advertisement
Table of Contents
