Step 1: Before Use - Venen Engel 4 Operating Instructions Manual

APPLICATION

STEP 1: BEFORE USE

CONNECT AIR HOSES
Connect the set of hoses to the cuffs, starting with the dark gray
connector, and then plugging the other gray connectors onto the
appropriate counterparts.
Note: We recommend that you do not detach the connectors
afterward.
Note: For users of combination sets with leg cuffs and belly cuff;
the two long ends of the tube set correspond to the legs and the
short end to the belly.
Device Set-Up
Ensure that the device is securely placed. Also make sure that the device is free standing and not covered by a blanket, or similar. Do not
use the device in damp rooms or those with high humidity, such as in saunas or bathrooms.
Tightening Leg cuffs
To prevent contamination, we recommend wearing leggings or sweatpants when using the device. Empty your pockets before
application!
The zippers on the cuffs must be completely closed to avoid the cuffs from suddenly splitting open and causing possible damage.
After plugging it into the power plug, putting on the cuffs, and tightening the zipper, the Venen Engel application controls on the control
unit can be adjusted.
Information: Always make sure that the hoses are not kinked, and that you are not sitting on the hoses.
Attaching the Multi-plug
Plug the multi-plug into the front of the device as far
as it will go. Be sure to insert the multi-plug into the
device the right way (the small nippte into the small
hole).
EN
28