Keyence Plc Kv 7300 And Vh5/Vh6; System Configuration; Parameter Setting; Setup Steps - Xinje VH5 Series User Manual

10.6 KEYENCE PLC KV 7300 and VH5/VH6

10.6.1 System configuration

Name
Upper computer
Controller
Communication
card
Network cable
USB cable

10.6.2 Parameter setting

The frequency converter slave station needs to be configured as EtherCAT communication mode, and the
parameters to be modified are as follows:
Parameter
P0-02
P0-03 Main frequency
A input channel
P9-00 Communication
Slave station
P9-12

10.6.3 Setup steps

1)New project
①The computer and PLC are connected and communicated through USB port.
②Open the software and create a new project.
Model
KV STUDIO Ver.9G
KV_7300 series
VHX-CC100(V2.0)
JC-CB-3
USB cable
Name Access
Operation
command Runtime
channel read only
selection
Runtime
read only
selection
Runtime
protocol read only
RW
No.
Quantity
1 Omron upper computer software
1
1
some For connection between PLC and slave
For connection between computer and
-
Set value Range
2 0-2
6 0-9
1 0-2
- 0-65535
64
Explanation
-
-
PLC
Explanation
Communication
Communication setting
EtherCAT
After modification, it is
valid when power on again.