Advertisement
RT2760 QSG EN A ver.
15/3/06
11:17 AM
Page 2
Connecting the speakers
Six speakers are provided with the unit (2 front, 1 center, 2 rear, 1 subwoofer). To achieve good
surround effects, all six speakers need to be connected to the receiver.
Speaker wires are color-coded to match the terminals.
Note: When connecting subwoofer, connect subwoofer control cable to the unit's rear panel first,
then press the power switch on the subwoofer speaker to switch it on.
Positioning the speakers
Factory defaulted Advance setting indication from VFD
The receiver has defaulted the following distances:
Front speakers (FRNT)
15 ft
Center speaker (CNTR)
15 ft
Surround speakers (SURR)
10 ft
Speaker Configurations
You can also change the setup of the speakers.
Use a subwoofer to enjoy optimum sound.
• Speaker distance: For optimum surround experience measure the distance
between the speaker and your favorite listening position.
1. Press the SETUP or DISTANCE button to show setup options.
2. Press the Left or Right adjustment
buttons until the speaker you want to change is displayed.
3. Press the Up or Down arrow buttons to change the speaker settings.Your
selection will be stored automatically.
4. Repeat step 2 and 3 to set up the next speaker.
Center Speaker selection (CTR)
YES / NO
Surround Speaker selection (SURR) YES / NO
Front Speaker distance (FRNT)
3-40 ft
Centre Speaker distance (CNTR)
0-40 ft
Surround Speaker distance (SURR) 0-40 ft
5. When set up is done, wait for 5 seconds to automatically save your settings
or press any key to save your selection and set up mode.
Front
Front
Center
Left
Right
Cch
Lch
Rch
L/S
R/S
Rear
Rear
Left
Right
Note: By default, the Center and Surround Speakers are set to
YES. If you decide not to use them, set the ones you do not
intend to use to NO so the sound performance is not affected.
Connecting to Audio Components
DIGITAL CONNECTION
If you have a SAT receiver or DVD player with a digital output, you can make use of an optical digital cable (not supplied)
or coaxial digital cable (included) to carry the audio portion of the signal and enjoy Dolby Digital sound quality. One
optical or coaxial cable is needed for each SAT receiver or DVD player. When optical or coaxial cable is used, the analog
audio cables are still needed if recording through a VCR is desired. This receiver provides one optical and one coaxial
digital input for the connection of your components. Please connect your components (e.g. DVD or SAT) to the appropriate
digital inputs and press SETUP to select the corresponding digital input source.
Note: Optical and COAXIAL cables carry only the audio portion of the signal.
COAXIAL OPTICAL
SAT/CAB
DVD
Advertisement
