Hitachi 55HAK5351 Instruction Manual page 14

5
In t al Setup W zard
When turned on for the first time, a search for accessories will be performed before the initial setup starts.
Follow the on-screen instructions to pair your remote control (depends on the model of the remote control)
and other wireless accessories with your TV. To pair your remote press and hold the Source button for about 5
seconds. Press Back/Return to end adding accessories and start the setup. After that welcome screen will be
displayed. Select your language and press OK. Follow the on screen instructions to set your TV and install
channels. The installation wizard will guide you through the setup process. You can perform initial setup
anytime using the Reset option in the Settings>Device Preferences menu. You can access the Settings menu
from the Home Screen or from the TV options menu in Live TV mode.
Tivusat Installation
You can search and store Tivusat channels. Set the Satellite Type as Preferred Satellite and then set the
operator accordingly. Press OK or the Right directional button to proceed.
Note: If you want the channels to be sorted in the preset order of Tivusat set the satellite as Hotbird at 13.0º
East (13.0E).
Note: For deta led nformat on and nstruct ons on the n t al setup process refer to the Insruct on Book of th s
TV.
6
Change the Input Source
If you want to connect a dev ce to the TV, make sure that both the TV and the dev ce are
turned off before mak ng any connect on. Use a su table cable to connect two un ts
together.
Once you have connected external systems to your TV, you can sw tch to d fferent nput
sources. Press the Source button on your remote control consecut vely or use the
d rect onal buttons and then press the OK button to sw tch to d fferent sources when n L ve
TV mode. Bes des th s, you can sw tch to the des red nput source by select ng the des red
opt on from the Inputs menu on the Home Screen or TV opt ons >Source menu n L ve
TV mode.
7
Connect your TV to the Internet
You can access the Internet v a your TV, by connect ng t to a
broadband system. It s necessary to conf gure the network
sett ngs n order to enjoy a var ety of stream ng content and nternet
appl cat ons. These sett ngs can be conf gured from the Network
& Internet menu located under the TV opt ons>Sett ngs menu n
L ve TV mode or under the Sett ngs menu on the Home Screen.
You can also h ghl ght the Connected/Not Connected con on the
Home screen and press OK to access th s menu.
W red Connect on
Connect your TV to your modem/router v a an Ethernet cable.
There s a LAN port on the rear s de of your TV.
The status of the connect on under the Ethernet sect on n the
Network & Internet menu w ll changed from Not connected to
Connected.
W reless Connect on
A w reless LAN modem/router s requ red to connect the TV to the
Internet v a w reless LAN. H ghl ght W -F opt on n the Network &
Internet menu and press OK to enable w reless connect on.
Ava lable networks w ll be l sted. H ghl ght your network from the
l st and press OK to connect.
password to connect to the selected network, in case the network is
password protected.
You may be asked to enter a
Engl sh
Broadband
ISP connect on
LAN (Ethernet) cable
LAN nput on the rear side of the TV
Broadband
ISP connect on