Flyte MTI-1 Quick Start Manual

#FLYTEISMYSUPERPOWER
Welcome to Flyte!
Let's get started!
First, please visually inspect Flyte
for anything unusual (cracks, tears,
exposed wires).
Please also register your Flyte (see
page 28 of the Instructions for Use).
Please review the Instructions for Use
for complete information.
2
Clean Flyte
Clean the wand before first use and
after each use. Unplug the wand from
the biofeedback controller prior to
cleaning.
To clean your Flyte wand wipe off any
obvious residue with a clean cloth,
simply clean using mild soap and
water for 20 seconds, rinse, and wipe
dry with a clean cloth.
Now you are ready to use Flyte!
WARNING: Do not submerge the biofeedback unit, the charging cable, the wall charger, or the wand in water.
SIDE 1
1
Charge Flyte
Plug the USB end of the cable into the charging block. Plug the black end of the charging cable into the biofeedback controller
(round unit) until you hear a click. Plug the charging block into the wall. Flyte takes about 2 ½ hours to fully charge.
You will know Flyte is charging when the charging light is yellow. When the yellow charging light turns off, Flyte is fully charged.
Unplug and store the charging cable and charging block. We recommend that you recharge the battery weekly or as needed.
If during charging the yellow light does not come on, it is likely Flyte does not need to be charged. Continue to use as directed.
3
Insert Flyte
Find a comfortable and private place for your treatment session where you can
concentrate for 5 continuous minutes. We recommend lying on your back but
choose a position that is comfortable for you. As you gain strength and tone,
that position may change (feel free to contact our Ask a PT service for options).
Connect the wand to the biofeedback controller until you hear a click
Fully insert the wand like you would insert a tampon (If necessary for
comfort, apply a small amount of water-based vaginal lubricant to yourself
and to the wand, or cover the wand with a lubricated non-latex probe cover
or condom).
Make sure that the longer "wing" is facing the front of your body and that
both wings are resting comfortably on your skin. Do not insert the wings
into your vagina.
Quick Start Guide
In-Home Pelvic Floor Treatment Model MTI-1
4
Turn Flyte on
Turn the controller on by firmly squeezing
and holding the ON/OFF button between
your thumb and index finger for 1 to 2
seconds.
When you see the "On" light turn green, let
go of the ON/OFF button. You will then see
one blue light blink.
Flyte will now guide you through your
5-minute session!
USING FLYTE (SIDE 2)