Flyte MTI-1 Quick Start Manual

Quick Start Guide
SIDE 1
In-Home Pelvic Floor Treatment Model MTI-1
Check it out.
1
Visually inspect the
device before use for
anything unusual (cracks, Plug it into the wall. You will know Flyte™ is charging when
tears, exposed wires). the charging light is yellow.
When the charging light turns off, the device is fully
charged and you should disconnect and store the charging
cable and unit. A full charge will take at least 2.5 hours.
Pelvital recommends that you recharge the battery weekly.
Choose place &
position.
4
Choose a private
area where you will
be able to concentrate
solely on the exercise for 5
continuous minutes.
Choose either a standing
or sitting position to use
the device for the duration
of the 5-minute therapy.
For best results, you
should remain still in the
same position for the full 5
minutes.
Please review the Instructions for Use, included with
the Flyte™ system, for complete information.
Charge it.
2
Before use, charge the device by plugging the USB
cable into the receptacle on the biofeedback unit.
Insert the device.
5
Apply a small
amount of water-
based vaginal lubricant vagina, plug the USB cable
to the wand or apply a on the end of the wand into
lubricated probe cover. the biofeedback unit.
Get into position and fully
Turn Flyte™ on by pressing
insert the wand into your
the On/Off button on
vagina, with the longer
the bottom center of the
wing facing the front of
device for one second. The
your body. If you encounter
product is on when the
excessive discomfort,
green "On" indicator light is
remove the wand and
displayed.
contact our customer care
team at 1-866-PELVITAL
or info@pelvital.com.
3
use. Unplug the wand from the biofeedback unit prior to
cleaning the product.
To clean and disinfect the wand and biofeedback unit:
• Wash your hands.
• Use a clean, damp cloth to remove any obvious residue
• Use a Dispatch® Cleaner Disinfectant Towel (or
Plug in & turn on.
6
Once the wand is
inserted in your
• Use a clean, damp cloth to remove residual cleaning
• Use a second disinfecting wipe to disinfect the wand and
• Apply mild soap to the wand and rinse thoroughly with
Clean & disinfect it.
Clean and disinfect the wand before its first use,
after each use, and again before each subsequent
from the wand.
equivalent disinfecting wipe that contains no more than
1% sodium hypochlorite) to remove any residue from the
outside of the wand. Discard the wipe.
agent from the wand's surface. NOTE: Use only a soft
cloth or wipe to clean the wand. Abrasive materials can
damage the wand.
biofeedback unit, wiping all outside surfaces thoroughly.
Discard the wipe and allow the wand's surface to remain
wet for 5 minutes.
WARNING: Do not submerge the biofeedback
unit, the charging cable, the wall charger, or the
wand in water.
water to remove residue. Please ensure that all of the
soap is rinsed off. Wipe with a clean cloth, and then air
dry.
USING THE DEVICE (SIDE 2)