Maintenance; Specifications - Heco VICTA ELITE SUB 252A Owner's Manual/Warranty Document

Cross-over frequency control (8)
Used to set the upper limit of the subwoofer operating range. The cross-over frequency should be set to
approxi-mately 100 to 150 Hz when the system is used in combination with shelf loudspeakers and to
50 to 100 Hz with stand loudspeakers.
Phase switch (9)
In normal use the phase switch should be set to 0°. However, in rare cases it may be advantageous to set
the phase to 180° (e.g. if the subwoofer is far away from the front satellites or in the event of unfavourable
acoustics in the room). Generally speaking: the setting where the lower base tone area has a fuller sound
is the correct one.
Fuse (10)
Only use a fuse with the parameters indicated next to the fuse holder on the rear of the amplifier.

MAINTENANCE

Please use a soft, dry cloth with no cleaning agents, sprays or chemical solvents, as these could
damage the surfaces.

SPECIFICATIONS

Configuration:
Fitted with
Output power RMS/Max.:
Frequency range:
Cross-over frequency:
Dimensions (WxHxD):
Accessories:
Subject to technical change.
Powered bass reflex subwoofer, „frontfire"
principle
26 cm long-stroke driver
100 / 200 watts
22 – 150 Hz
50 – 150 Hz, adjustable
334 x 458 x 410 mm
mains cable
10