If you have questions or problems with installation, contact CAUTION your Dacor dealer or the Dacor Customer Service Team. Hazards or unsafe practices that COULD result in minor Dacor Customer Service personal injury or property damage.
mportant afety nstructIons To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: WARNING If the product is damaged, immediately contact the dealer or builder. Do not install or use a damaged appliance. Do not use the coffee system until it has been properly installed by a qualified installer according to these installation instruc- tions.
Serial Number Any questions or problems with this installation Label should be directed to your Dacor dealer or the Dacor Customer Service Department. Dacor Customer Service 1-800-793-0093 (U.S.A. and Canada) Monday — Friday 6:00 am to 5:00 pm Pacific Time e-mail: customerservice@Dacor.com.
Dacor highly recommends installation of • The coffee system is supplied with a 60” (1524mm) a Dacor ACFS flushing system (not included) with long power cord terminated by a three-prong plug. The model CM24P. The coffee system requires periodic power cord is intended to be plugged directly into a decalcification regardless of the water hardness level.
CM24T, be able to remove the water tank for filling and cleaning. Install the coffee maker low enough so that the user can reach the top of the unit easily when it is slid out of the cabinet.
• Teflon tubing (model CM24P only) pressure gauge, and a mounting bracket. • Spare tank O-ring (model CM24T only) • Assemble the pressure regulator gauge, gauge O-ring, • Spare piston assembly O-ring and two of the quick-release fittings as shown.
nstallatIon nstructIons • Cut a section of the supplied Ø 4mm (5/32”) Teflon hose long enough to connect between the coffee system water inlet quick release fitting and the regulator without binding or kinking. • Insert one end of the Teflon hose (Ø 4mm) into the quick-release fitting on the appliance.
nstallatIon nstructIons nstallIng the abInet lIdes • Put the two cabinet glide assemblies, and shims if The cabinet glides mount to the inside of the cabinet. necessary, as shown on the inside surfaces of the The glides on the coffee system slide into the cabinet cabinet.
Check to make sure the pressure regulator is set between 1.5 bars to 3 bars pressure. Adjust the regulator if necessary. • On model CM24T (tank model): Fill the tank with filtered water (4 gpg maximum water hardness, do not use distilled water). •...
nstallatIon nstructIons nstallatIon hecklIst WARNING WARNING: • To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. • Proper installation is the responsibility of the homeowner.