Summary of Contents for Certance LTO Autoloader
-
Page 1: Installation Guide
LTO Autoloader Barcode Reader Installation Guide Part Number 10010534-001 April 2003 Rev. B January 2004 Copyright © 2004 Certance LLC. All rights reserved. -
Page 2: Table Of Contents
LTO Autoloader Barcode Reader Contents Required tools:... 3 Mounting instructions:... 3 Using the Barcode Reader ... 4 Barcode labels ... 4 Removing the Barcode Reader ... 4 Bar Code Label Specification ... 5 About this Specification ... 5 Symbology ... 5 Bar Code Characters ... -
Page 3: Required Tools
LTO Autoloader Barcode Reader Required tools: Small flat-blade screwdriver Mounting instructions: ATTENTION! ESD Sensitive Component. Please touch unit cover or rear panel before installing the barcode reader to avoid electrostatic discharge. 1. The barcode reader is to be mounted on the rear side of the autoloader. -
Page 4: Using The Barcode Reader
LTO Autoloader Barcode Reader Using the Barcode Reader The barcode reader is controlled through the host software. There is no user interaction, and the Operator Panel does not indicate that a barcode reader has been added. When you next power up the autoloader, the barcode reader is automatically enabled for scanning. -
Page 5: Bar Code Label Specification
LTO Autoloader Barcode Reader Bar Code Label Specification For LTO Ultrium 1 Cartridges About this Specification This document defines format and contents of the external barcode label to be used on LTO cartridges. The specifications are defined to both standardize labels and allow users the option of purchasing or printing their own labels. -
Page 6: Optical Specification
LTO Autoloader Barcode Reader Optical Specification The optical specifications for the bar code labels are listed below. Use the white calibration standard to calibrate the print contrast of the Mcbeth PCMII. Be sure the filter select switch is on position A for all calibration and measurements. - Page 7 LTO Autoloader Barcode Reader The following table lists the bar code label dimension specifications. Specification Symbol height Wide to narrow ratio Narrow element width Nominal width of wide spaces and bars Inter character gap Bar code element width maximum Quiet zone at the beginning and...
-
Page 8: Volume Identifier Formats
LTO Autoloader Barcode Reader Volume Identifier Formats The volume identifier only uses ASCII characters A through Z (41h-5Ah), 0 through 9 (30h-39h), and the combinations of “CLN” and “DG {space} ” as described below. The prefix “CLNvnnL1”is reserved for cleaning cartridges. The “v” field is an alphanumeric field to identify a drive unique cleaning cartridge.