Impulse Dynamics OPTIMIZER Integra CCM-D Patient Manual page 49

Electrical fast ± 2 kV for mains
transient / power supply
burst as
± 1 kV for in-
defined in
/output lines
IEC 61000-4-4
AC line ± 2 kV Common
voltage surges Mode
as defined in
± 1 kV Differential
IEC 61000-4-5
Mode
1.2/50 µs
Voltage dips, 0%, 0.5 cycles at
short 0°, 45°, 90°, 135°,
interruptions 180°, 225°, 270°,
and voltage and 315°
variations on
0%, 1 cycle
power supply
70%, 25 cycles
input lines as
defined in 0%, 250 cycles
IEC 61000-4-
11
Power line 30 A/m
frequency
magnetic
fields (50/60
Hz) as defined
in IEC 61000-
4-8
Conducted RF 3 V r.m.s outside
as defined in industrial,
IEC 61000-4- scientific, and
6:2013 medical (ISM) and
amateur radio
bands between
0.15 MHz and
80 MHz, 6 V r.m.s.
in ISM and
amateur radio
bands between
0.15 MHz and
80 MHz
± 2 kV for mains
power supply
± 1 kV for in-
/output lines
± 2 kV Common
Mode
± 1 kV Differential
Mode
1.2/50 µs
0%, 0.5 cycles at
0°, 45°, 90°, 135°,
180°, 225°, 270°,
and 315°
0%, 1 cycle
70%, 25 cycles
0%, 250 cycles
30 A/m
3 V r.m.s outside
industrial,
scientific, and
medical (ISM) and
amateur radio
bands between
0.15 MHz and
80 MHz, 6 V r.m.s.
in ISM and
amateur radio
bands between
0.15 MHz and
80 MHz
43
Mains power quality should
be that of a typical home
healthcare, business, or
hospital environment.
Do not operate motors or
other noisy electrical
equipment on the same
mains circuit as the Guardio
Charger.
Mains power quality should
be that of a typical home
healthcare, business, or
hospital environment.
Mains power quality should
be that of a typical home
healthcare, business, or
hospital environment.
Note: If the user of the
Guardio Charger requires
uninterrupted operation
during power mains
interruptions, it is
recommended to power the
Guardio Charger from an
uninterruptible power supply.
Power line frequency
magnetic fields (50/60 Hz)
should be at levels expected
in a typical home healthcare,
business, or hospital
environment.
Portable and mobile RF
communications equipment
should be used no closer to
any part of the device,
including cables, than the
recommended separation
distance calculated from the
equation applicable to the
frequency of the transmitter.
Recommended separation
distance:
d = 1.17√P