Brother SE1800 Operation Manual page 150

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
EMBROIDERY
e Loosen the presser foot holder screw and
remove the presser foot holder.
Turn the screwdriver toward the back.
a
c
a Screwdriver
b Presser foot holder
c Presser foot holder screw
f Hold the embroidery foot with your right
hand, as shown.
Hold the embroidery foot with your index
finger wrapped around the lever at the back of
the foot.
a
a Lever
b Embroidery foot bar
g While pressing in the lever with your finger, fit
the embroidery foot bar over the needle clamp
screw to attach the embroidery foot to the
presser foot bar.
a Embroidery foot bar
b Needle clamp screw
148
h
b
i
b
1
2
Secure the embroidery foot with the presser
foot holder screw.
Set the embroidery foot perpendicular.
a
a Mounting notch
b Presser foot holder screw
Firmly tighten the presser foot holder screw.
Turn the screwdriver toward the front.
CAUTION
● Do not hit the needle with your finger or
the embroidery foot "Q" when attaching
it. The needle may break or cause injury.
● Be sure to tighten the screw with the
included screwdriver. If the screw is
loose, the needle may hit the presser foot
and break or bend.
● Before sewing, always turn the handwheel
toward you (counterclockwise) slowly to
make sure that the needle does not hit the
presser foot. Otherwise, the needle may
break or bend.
b