Quantum DLT 4000 Install Manual page 2

Quantum Corporation
_____________________________________________________________________________________________
Perform the installation as follows:
Shut down the HP9000/800 and remove ac power from the system. Install the DLT tape peripheral and
connect it to its SCSI controller. Depending on the DLT tape peripheral you are installing, refer to one of
the following manuals for switch and jumper settings and SCSI bus termination:
DLT2000/DLT2700 product manual (order number 81-109132)
DLT2500 owner's manual (order number 81-109374)
DLT2000XT/DLT2500XT/DLT2700XT product manual (order number 81-109253)
DLT4000/DLT4500/DLT4700 product manual (order number 81-106336)
DLT7000 tape Drive product manual (order number 81-60000)
DLT8000 tape Drive product manual (order number 81-60118)
Set the DLT SCSI device address to an unassigned SCSI ID.
Turn power on and boot the system. Log on as root.
Copy patch to the /tmp directory.
Change directory to /tmp.
Enter the following command to unpack the patch:
sh <PATCH>
<PATCH>is the patch file name.
To complete the patch installations, follow the instructions as described in /tmp/<PATCH>.text. Some of
the patch installations may include a system reboot. Once the patch is installed, the installation will be
complete.
Files /tmp/<PATCH>.text and /etc/newconfig/DLT.README may contain additional information regarding
DLTtape device verification and use. Although the fbackup command appears to work with DLTtape tape
peripherals, it should be noted that the frecover command does not.
Copyright 1999-2001 Quantum Corporation or its subsidiaries or affiliates. All rights reserved
DLTtape Application Note