Initializing The User Data - Samsung MIM-H05UN User & Installation Manual

LED display during tracking
If communication is normal but there are only the indoor units with the central control disabled.
• Reset the central control option on the indoor units. When the central control is disabled, the indoor
units cannot be controlled with the Wi-Fi kit.
Wi-Fi connection LED
Blinking
Off
On
Blinking
• Setting the option code for the Wi-Fi Kit
- After installing the Wi-Fi Kit on the indoor unit, be sure to change the central control option (SEG5)
as follows.
- Set the option code to [0D2051] as shown below.
Function Page
Indicator on
the remote
control
Indication Details Indication Details
Indication
and details
0
If no indoor unit is tracked
• Check whether the communication cables between indoor units and the Wi-Fi Kit are connected
properly.
Wi-Fi connection LED
Blinking
Blinking
Blinking

Initializing the user data

• To initialize the user data on a Wi-Fi Kit, press the (SW3) button inside the Wi-Fi Kit for 5 seconds. All the
indicators illuminate and the user data is deleted.
Wi-Fi setting LED
Blinking
On (Green)
On (Yellow)
Blinking
Option mode to
Mode
change
Indication
D Option mode
Wi-Fi setting LED
Blinking
Off
Blinking
Time
Off About 10 seconds
Off
Alternating every 10
seconds
Off
Off About 10 seconds
Tens position of the
option SEG
Details Indication Details
Tens position
2 0
of SEG
Time
Off About 10 seconds
Off About 10 seconds
Off About 10 seconds
Status
Tracking
Only the units with the
central control disabled
Tracking
Units position of the
option SEG
Indication Details Indication Details
Units position
5
of SEG
Status
Tracking
check communication
Tracking
1
17