Screen Maintenance - Philips EVNIA 42M2N8900/00 User Manual

8. Screen maintenance

Following the characteristics of
OLED displays, there are automatic
mechanisms used to protect the screen
and reduce image sticking which may
request an opportunity to run the refresh
process. These mechanism settings may
be adjusted in the On-Screen Display
(OSD) menu under OLED Panel Care.
SmartImage Game Mode Ambiglow
Power LED Screen Saver
Language Pixel Orbiting
Resolution Notice Pixel Refresh
CEC Panel Refresh
OLED Panel Care Auto Warning
Information
Reset
Resolution Refresh Rate
3840X2160 60Hz
• Screen Saver
When a static image is detected for a
certain period of time, the screen saver
function will dim the screen to protect
the panel from sticking. When a moving
image is detected, the monitor will
recover luminance to previous working
status. Default setting is On and would
highly recommend that you always set
it as On to protect the screen. It is also
recommended that you also set your
device to use a screen saver.
• Pixel Orbiting
Pixel shift moves the image a couple
of pixels at regular intervals to avoid
potential sticking. This is not noticeable
in normal circumstances. Default setting
is On and would highly recommend that
you always set it as On to protect the
screen.
• Pixel Refresh
After a cumulative usage over 4 hours,
Pixel Refresh will be activated to
compensate the image sticking. When
it is activated, screen will be in standby
Input Audio System Setup
On On
On Off
No
No
On
Input Source Adaptive Sync SmartImage
HDMI 1 Off Standard
mode for 3 minutes to finish the whole
process.
There will be a 1
4-hours and you can choose to proceed
the refresh process or skip it. If you
choose to skip it, there will be more
reminders after every 2 hours. After
cumulative usage of 16 hours, you will
not be able to skip it. If you cannot
execute Pixel Refresh upon receiving the
reminders, you can still go to OSD menu
at your feasible time to proceed the
Close
process.
A reminder message that pops up after 4 hours of
Select
continuous use, and will then appear every 2 hours
OK
after.
Back
To maintain the panel quality, Pixel Refresh will automatically
run after in use for a periods of time.
Pixel Refresh will take few minutes and Power LED will blink until
it is �nished.
Please do not unplug the power cable during the process.
Accumulative usage: 4HOURS
Do you want to activate Pixel Refresh now?
Compulsory execution message
To maintain the panel quality, Pixel Refresh will automatically
run after in use for a periods of time.
Pixel Refresh will take few minutes and Power LED will blink until
it is �nished.
Please do not unplug the power cable during the process.
Accumulative usage: 16HOURS
Proceed
• Panel Refresh
After cumulative usage over 500 hours,
Panel Refresh will run automatically
to adjust the uniformity of OLED to
prevent image retention caused by static
content. When it is activated, screen
will be in Standby mode for 30 seconds
to finish the process. Also, you cannot
skip Panel Refresh process but it could
be finished simultaneously while the
monitor goes into standby mode for
over 2 hours or while you turn off the
monitor.
22
st pop-up message after
Yes No