2.3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
Display base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the monitor face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. Loosen the assembly screws, then
detach the neck from the monitor.
3. Gently attach the latch to the VESA
until the latch locks the VESA.
1
2
1
2
Note
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always
contact manufacturer for wall-mount
installation.
* Display design may differ from those
illustrated.
Warning
•
To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
•
Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
10
0°
-5°
90°