Table of Contents
Advertisement
3 Load drives in the drive trays.
• For 3.5" drives: Remove the fastening panels from the sides of the drive tray. Place the drive in the drive
tray. Then insert the fastening panels to secure the drive in place.
• For 2.5" drives: Remove the fastening panels from the sides of the drive tray and put them in a safe place.
Place the drive in the blue area (shown below) of the drive tray, turn the tray upside down, and then tighten
the screws provided to secure the drive.
4 Insert the loaded drive tray into the empty drive bay. Make sure the side marked with "UP" is facing up, and
insert the drive tray into the empty drive bay. You should hear a click when the tray is locked in place.
5 Repeat the steps above to install the other drive if you have prepared one.
7 Chapter 2: Hardware Setup
Advertisement
Table of Contents
