Polaris GENERAL 1000 2017 Owner's Manual For Maintenance And Safety page 38

FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Engine Error Codes
The error screen displays only when the CHECK ENGINE indicator is on or when it goes on
and off during one ignition cycle. Error codes are not stored. When the key is turned OFF, the
code and message is lost, but will reappear if the fault reoccurs after restarting the engine.
If the CHECK ENGINE lamp or the EPS
lamp illuminates, retrieve the active error
codes from the display.
1. Press and hold the MODE button to enter
the settings menu.
2. Press either toggle button to cycle to the
"DIAGCODE" option. Press MODE to
select.
3. More than one diagnostic code may be
present. Press the toggle UP button to
see if more codes are present. Press
MODE to select a code.
NOTE:
If the displayed code is an engine fault
code, the CHECK ENGINE lamp will
blink. If the displayed code is an EPS
fault code, the EPS lamp will blink.
4. Record the three (3) numbers displayed.
5. Press MODE to exit to the settings menu.
36
Suspect Parameter
Number (SPN)
Code Count
Failure Mode
Indicator (FMI)