Asus PRIME H310M2 R2.0 Manual page 10

ATX power connectors (24-pin EATXPWR, 8-pin ATX12V)
Correctly orient the ATX power supply plugs into these connectors and push down
firmly until the connectors completely fit.
•
•
•
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside
the system may damage the motherboard components. These are not jumpers! Do not
place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan
of maximum 1A (12W) fan power.
Intel LGA1151 CPU socket
®
Install Intel
designed for 8th Generation Intel
processors.
For more details, refer to Central Processing Unit (CPU).
DDR4 DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these
DIMM sockets.
For more details, refer to System memory.
Intel H310 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
1-2
For a fully configured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12V Specification 2.0 (or later version) and provides
a minimum power of 350 W. Ensure this PSU type has 24-pin and 8-pin power
plugs.
We recommend that you use a PSU with higher power output when configuring a
system with more power-consuming devices or when you intend to install additional
devices. The system may become unstable or may not boot up if the power is
inadequate.
DO NOT forget to connect the 8-pin ATX +12V power plug. Otherwise,the system
will not boot up.
LGA1151 CPU into this surface mount LGA1151 socket, which is
®
Core™ i7 / i5 / i3, Pentium
®
Chapter 1: Product introduction
, and Celeron
® ®