Hunter 50235 Installation Manual page 9

Remove the cardboard plug
guard before proceeding!
Connect the plugs from
the fan and light fixture.
Make sure to line up
the colored markings
on the connectors.
Need a little more help with assembling this light?
Visit our light kit video at:
Repeat x3
Ceiling Bracket Downrod
Push the connector and
excess wire into the hole at
the top of the light fixture.
IMPORTANT
The connector and excess wiring
must be pushed into the light
fixture in order to successfully
mount the light fixture to the fan.
HOLD HERE
http://bit.ly/HunterQuickConnect
Installing the Bulbs and Glass
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Hanging Fan Wiring
Assembling the Light
Raise the light kit to the bottom of the fan.
Align the notch on the mounting ring on the
top of the light kit with the pin in the mounting
bracket on the bottom of the fan.
To install the shade, first loosen
the thumb screws. Raise the
shade to the light fixture. Tighten
all thumbscrews securely.
Repeat x3 Repeat x3
Canopy Blades
Some components not shown for visual clarity.
Hold the fan body stationary and rotate
the light fixture clockwise to engage the
locking pin.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light Remote
1886
Notch
Pin
ON
8
Troubleshooting