Table of Contents
Advertisement
1886
Partially install two switch housing screws, found
in the
hardware bag, through the gasket
halfway into the motor housing as shown. It does
not matter which two screw holes you choose.
Lift the the lower switch housing and
connect the plugs. Make sure to line up the
colored markings on the connectors and
that the connectors latch.
Lift the cap and align cap
holes with the extend tabs
of the fan housing.
7
Ceiling Bracket
Installing the Blades
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Installing the Switch Housing and Cap
2 of 3
Switch Housing
bag
Screw
Feed the wire plug through the center hole of the uppers
switch housing. Align the keyhole slots in the upper
switch housing with the two screws you just installed.
Lift the upper switch housing so that the keyhole slots
engage the two screws, and twist counterclockwise to
lock the upper switch housning into place.
Downrod
Hanging Fan
Put the blade washers found in the
bag onto the blade screws found in the
hardware bag. Then install the blade screws to
secure each blade to the fan.
Repeat x3
Using the three short housing
screws found in the
hardware
bag, mount the lower switch
housing to the upper switch housing.
Insert the cap screws found in
the hardware bag
Wiring
hardware
Blade Screw
bag
Blade Washer
bag
bag
Insert the third screw found in the
hardware bag, into place and then tighten all
three screws.
4 of 4
Cap Screw
bag
Note:
Fan style may vary.
Canopy
Blades
x9
x9
1 of 3
Switch Housing
Screw
3 of 3
Short Housing
Screw
bag
ON
Control
Advertisement
Table of Contents
