Garland BOLT 115 G Instruction Manual page 32

English
ventilation. Do not return to work in the area until you
are sure that you have properly ventilated the area
and are clear that ventilation is sufficient as to not
happen again in this concentration
Do not refuel fuel in locations where there is the
presence of open flames, sparks or heat sources. Fill
the tank always in well-ventilated areas and with the
motor stopped. Not overflow the fuel to overfill the
fuel tank. In the event of a fuel leak be sure to remove
these leaks completely before starting, move the
machine away from the area of spillage and avoid any
source of ignition until all vapors are gone.
Separate yourself at least 3 meters from the refueling
area before starting the machine.
Add fuel before starting the machine. Never remove
the cap of the fuel tank while the engine is running or
when the machine is hot.
Do not use fuels such as ethanol or methanol. These
fuels will damage the engine of the machine.
6.4. START-UP
6.4.1. VERIFICATION POINTS BEFORE
COMMISSIONING START-UP
Do not use machine is if it is damaged or incorrectly
regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user, for the machine and for persons, animals and
things in its surroundings.
Verify:
• The machine completely and look for parts (bolts,
nuts, etc.) that are loose or damaged.
• That there are no fuel leaks.
• The oil level.
• That the air filter is clean. Clean the filter if
necessary.
Tighten, repair or replace everything you need to
before using the machine. Do not use any accessory
on this machine outside of those recommended by us
since its use could cause serious damage to the user,
the machine and people, animals and things close to
the machine.
6.4.2. PLACEMENT OF THE MACHINE
Make sure that you install the machine in a stable
position.
Connect a cable from the ground
generator grounding.
6.4.3. START-UP
Follow the start-up procedure in cold or hot depending
on the condition of your engine.
6.4.3.1. ARRANQUE DEL MOTOR EN FRÍO
ATTENTION! Before starting, make sure that no
electrical appliances connected to the generator.
• Place the machine on a flat, stable surface to start.
• Place the fuel tap in the open position (ON).
32/106
outlet of