Garland BOLT 115 G Instruction Manual page 31

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 22
6. START UP INSTRUCTIONS
6.1. UNPACKING AND LIST OF MATERIALS
This machine includes the following items that you will
find inside the box:
• Machine
• Instruction manual
Carefully remove all items from the box and make
sure that all listed items are present. Carefully inspect
the product to ensure that there are no damaged
elements.
If you find any damaged or missing parts, do not use
the machine until the defect has been repaired or
all the missing pieces replaced. Using the machine
without all of its parts or with defective parts can
cause severe personal injury.
6.2. ASSEMBLY
6.2.1. HANLDE ASSEMBLY
Install the handle on the top of machine using the
screws.
6.3.FUEL
IMPORTANT: The fuel used for this
machine is highly flammable. If the fuel or
the machine ignites, put out the fire with
a dry powder extinguisher.
Petrol and oil are extremely flammable
and explosive under certain conditions.
Do not smoke and keep flames, sparks or
heat away from the machine.
Use unleaded gasoline 95 octane.
Always avoid contact of gasoline or oil in eyes.
If gasoline or oil come in contact with eyes rinse
immediately with clean water. If you later feel irritated
eyes immediately consult with a doctor.
Do not use fuel that has been stored for longer than
2 months. A fuel stored for too long will cause the
starting of the machine to be more difficult and result
in unsatisfactory engine performance. If the fuel
has been in the machine's tank for longer than two
months, empty the tank and replace it with fuel in
perfect condition.
FILLING THE FUEL TANK
- Choose a suitable area to perform this operation.
- Remove the fuel tank cap and fill with fuel.
- Tightly close the fuel tank's cap and remove all the
fuel that spilled with a dry cloth.
WARNING:
Stop the engine before refueling.
Do not start the machine in a room or enclosure. The
exhaust gases, fumes from the fuel and oil contain
carbon monoxide and harmful chemicals. In the
case of a concentration of gases produced by poor
ventilation, remove everything that prevents the flow
of clean air from the work area in order to improve
31/106
English

Advertisement

Table of Contents
loading

Table of Contents