U-Line U3036RRINT00B User Manual & Service Manual page 65

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
10.Remove two evaporator cover screws from top of
evaporator cover to be removed.
Evaporator Cover
Screws
11.Grasp evaporator fan cover and gently pull plate away
from the rear of the unit.
12.While pulling the evaporator cover clear of the unit, it
may be necessary to use your free hand to manipulate
the fan plug end through the pass-through hole.
13.Remove the 4 screws mounting the fan shroud to the
evaporator plate.
14.Remove and replace fan. Take special care to properly
route fan wire.
NOTICE
Fan must be oriented to pull air in through lower
evaporator cover vents and push air out at fan
mounting location.
Evaporator Cover
Screws
Air Flow
15.Installation is the reverse of removal.
16.Care must be taken to assure that the bottom of the
evaporator cover gets reinstalled behind the front edge
of the drain trough.
17.Use sealant gum to seal any holes in the rear of the
unit before replacing the rear cover.
18.Reinstall the unit taking care to level, center and
secure as you found it.
65
Remove Fan and Cover 2