Advertisement
TROUBLE SHOOTING
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
Symptom
Cause
The car ignition is not on.
No power
The fuse is blown
Presence of CD disc inside
Disc cannot
the player
be loaded or
Inserting the disc in upside
ejected
down
Compact disc is extremely
dirty or defective
Temperature inside the
car is too high
Condensation
Volume is in minimum
No sound
Wiring is not properly
connected
The installation angle
Sound skips
is more than 30 degrees
The disc is extremely
dirty or defective
The radio does
The antenna cable is not
not work
connected
the signals are too weak
Solution
If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
Replace the fuse
Remove the disc in the player
then put a new upward
Insert the compact disc with
the label facing upward
Clean the disc or try to play a
new one
Cool off until the ambient
temperature returns to normal
Leave the player off for an
hour or so, then try again
Adjust volume to a desired level
Check wiring connection
Adjust the installation angle
to less than 30 degrees
Clean the compact disc/try to
play a new one
Insert the antenna cable firmly
select a station manually
5
2. RELEASE BUTTON
Press it to detach the front panel when you want to take away.
3. TUNING KNOB
Rotate it to select your desired broadcasting station.
4. CD COMPARTMENT
5. LCD (LIQUID CRYSTAL DISPLAY)
6. CDP
( CD PLAY, PAUSE) BUTTON
At tuner mode, press
button to switch to CD mode. At CD mode,
press it to pause the CD playing and press it again to resume CD
playback.
7. POWER BUTTON
Press it to turn on or off the unit.
8. EJECT BUTTON
Press it to eject the CD DISC.
9.10.TRACK UP/DOWN BUTTONS
a. During CD mode, press
Hold the
button to allow you to skip forward.
b. During CD mode, press
Hold the
button to allow you to skip backward.
9. 10.12. CLOCK ADJUSTMENT BUTTONS
During frequency display, press it to change to clock function.
Press CLK button for more than 2 seconds, until time flashes. and you can adjust
time now.
To adjust hour:
with time on display, push the tune
completed, release the button.
To adjust minute:
with time on display, push the tune
Is completed, release the button.
11. BAND BUTTON
Press it to select your desired radio band and the word which band is
selected will be displayed on LCD.
13. LUD/RDM BUTTON
LUD MODE:
When reduce the volume to half level, press it to enhance the bass effect.
button to allow you to track forward.
button to allow you to track backward.
button to adjust hour, when adjustment is
button to adjust minute. When adjustment
2
Advertisement
