Bosch Professional GCL 2-50 C Original Instructions Manual page 17

Point and line laser
Weight according to EPTA-Procedure 01:2014
G)
– With rechargeable battery
– With non-rechargeable batteries
Dimensions (length × width × height)
– Without holder
– With rotating mount
H)
Protection rating
Recommended ambient temperature
during charging
Permitted ambient temperature during
operation
Permitted ambient temperature during
storage
Recommended rechargeable batteries
Recommended chargers
A) The working range may be reduced by unfavourable environmental conditions (e.g. direct sunlight).
B) At 20–25 °C
C) The values stated presuppose normal to favourable environmental conditions (e.g. no vibration, no fog, no smoke, no direct sunlight). Ex-
treme fluctuations in temperature can cause deviations in accuracy.
D) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by condensation is expected.
E) Shorter operating times in Bluetooth® operation and/or in conjunction with RM 3
F) When using Bluetooth® Low Energy devices, it may not be possible to establish a connection depending on the model and operating system.
Bluetooth® devices must support the SPP profile.
G) Depends on battery in use
H) The lithium-ion battery and the AA1 battery adapter are excluded from IP 54.
Technical data determined using the battery that comes with the product.
The serial number (19) on the type plate is used to clearly identify your measuring tool.
Assembly
Measuring Tool Power Supply
The measuring tool can be operated either with conventional
non-rechargeable batteries or with a Bosch lithium-ion bat-
tery.
Operation with Rechargeable Battery
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your measuring tool.
Note: The use of batteries unsuitable for your measuring tool
can lead to malfunctions or damage to the measuring tool.
Note: The battery is supplied partially charged. To ensure
full battery capacity, fully charge the battery in the charger
before using your tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging process
does not damage the battery.
The lithium-ion battery is protected against deep discharge
by the "Electronic Cell Protection (ECP)". A protective circuit
switches the measuring tool off when the battery is drained.
Bosch Power Tools
GCL 2-50 C
0.62 kg
0.58 kg
136 × 55 × 122 mm
Dia.: 188 × 180 mm
IP 54 (dust and splash-proof)
0 °C ... +35 °C
–10 °C ... +50 °C
–20 °C ... +70 °C
GBA 12V...
(except for GBA 12V ≥ 4.0 Ah)
GAL 12...
GAX 18...
Do not switch the measuring tool back on after it has
u
been switched off by the protective circuit. This can
damage the battery.
To insert the charged battery (12), slide it into the battery
bay (11) until you feel it engage.
To remove the battery (12), press the release buttons (15)
and pull it out of the battery bay (11). Do not use force to
do this.
Operation with Non-Rechargeable Batteries
It is recommended that you use alkaline manganese batter-
ies to operate the measuring tool.
The batteries are inserted into the battery adapter.
The battery adapter is intended only for use in desig-
u
nated Bosch measuring tools and must not be used
with power tools.
To insert the batteries, slide the cover (13) of the battery
adapter into the battery bay (11). Place the batteries into
the cover as per the illustration on the sealing cap (16).
Slide the sealing cap over the cover until you feel it click into
place.
English | 23
GCL 2-50 CG
0.62 kg
0.58 kg
136 × 55 × 122 mm
Dia.: 188 × 180 mm
IP 54 (dust and splash-proof)
0 °C ... +35 °C
–10 °C ... +50 °C
–20 °C ... +70 °C
GBA 12V...
(except for GBA 12V ≥ 4.0 Ah)
GAL 12...
GAX 18...
1 609 92A 7LS | (11.05.2022)