Table of Contents
Advertisement
Automatic locking feature
To deactivate: press and hold button : for
X
about five seconds until a tone sounds.
To activate: press and hold button ; for
X
about five seconds until a tone sounds.
If you press one of the two buttons and do not
hear a tone, the relevant setting has already
been selected.
The vehicle is locked automatically when the
ignition is switched on and the wheels are turn-
ing.
You could therefore be locked out if:
the vehicle is being pushed.
R
the vehicle is being towed.
R
the vehicle is on a roller dynamometer.
R
You can also switch the automatic locking func-
tion on and off using the on-board computer
(
page 219).
Y
Power closing
Power closing pulls the doors into their locks
automatically even if they are only partly closed.
To power close a door: push the door into
X
the lock up to the first detent position.
Power closing will pull the door fully closed.
Unlocking/locking the driver's door
using the mechanical key
i
If you want to centrally lock the vehicle using
the mechanical key, begin by pressing the
locking button for the interior locking mech-
anism while the driver's door is open. Then
proceed to lock the driver's door using the
mechanical key.
Insert the mechanical key as far as it will go
X
into opening : in the protective cap.
Pull and hold the door handle.
X
Pull the protective cap on the mechanical key
X
as straight as possible away from the vehicle
until it releases.
Release the door handle.
X
To unlock: turn the mechanical key counter-
X
clockwise as far as it will go to position 1.
To lock: turn the mechanical key clockwise as
X
far as it will go to position 1.
Re-install the protective covering.
X
If you use the mechanical key to unlock and
open the driver's door, the anti-theft alarm sys-
tem will be triggered. Switch off the alarm
(
page 73).
Y
If you lock the vehicle as described above, the
fuel filler flap is not locked. The anti-theft alarm
system is not armed.
Doors
81
Z
Advertisement
Table of Contents
