Amer Mounts AMRP100B Mounting Instructions

MOUNTING INSTRUCTIONS
13.6kg(30lbs) max.
Amer Mounts
1-800-262-9703
Fax: 1-800-314-6805
Email: sales@amer.com
Technical support
1-888-998-918 9
Email: support@amer.com
WARNING STATEMENTS
Warning
The ceiling structure must be able to take a load of at
least equal to the maximum weight, 13.6 kilograms
(30lbs). If not, the ceiling must be reinforced. The
correct installation procedure, according to installation
instructions, should be undertaken only by a qualified
service technician.
Failure to do so may result in serious injury or death.
A secure structure must support the weight or load
of the projector mount. When mounting to a wall
that contains wooden studs, make sure to mark the
center of the wooden stud. This must be confirmed
prior to installation of screw fasteners.
Do not install on a structure that is prone to
vibration, movement or chance of impact. Failure
to do so could result in damage to the projector
and/or damage to the mounting surface.
Choose a location recommended by your projector
manufacturer.
Do not install near a heater, fireplace, direct
sunlight, air conditioning or any other source of
direct heat energy. Failure to do so may not only
reduce the performance of your projector, but may
result in damage to the projector and could
increase the risk of fire.
At least two qualified people should perform the
installation procedure. Injury and/or damage can
result from dropping or mishandling the projector
mount assembly.
Recommended hard mounting surfaces: wooden
studs and solid-flat concrete. If the mount is to be
installed on any surface other than wooden studs,
use suitable hardware (which is commercially
available).
amermounts.com
TOOLS REQUIRED NOT INCLUDED