Amer Mounts HYDRA1A Quick Start Manual

5
To properly balance the arm with monitors mounted, adjust the spring tension using the supplied
Allen Key as follows:
First, position and firmly hold the arm horizontally
as shown. Ask for assistance should you require it.
CAUTION:
To avoid damage to monitors or
mount, always keep the arm in a horizontal
position while making adjustments.
Again, ask for assistance if required.
6
O
If the arm drops, turn the adjustment
screw clockwise until it stays
in a horizontal position.
If the arm rises, turn the adjustment
screw counter-clockwise until it stays in a
horizontal position.
CAUTION:

·Do not over tighten the screws.
·To prevent damage to the Tension
Indicator, never allow the Red Indicator
Line move beyond the " " and " "
found on the Left and Right Side of the
tension indicator.
Instruction Manual
COUNTERBALANCE
MONITOR ARM
VESA Compatible
HYDRA1A
75x75 100x100
7
N
Tighten the limiting screw
(do not over tighten).
N
Remove or loosen the limiting screw.
8
Note:
If
the
display
does

not
stop
at
your
desired

position,
tighten
the

screws
as
shown.

Note:
If
the
display
does
not
stop
at
your

desired
position,

tighten
the
screw
as

shown.

N
32"
2~9kg
MAX
4.4~19.8lbs
RATED
FLAT/CURVED
±90° ±90°
Arm can rotate 180°.
±180° ±180°
Arm can rotate without stopping.
O
N