Setting The Temperature; Usb Port For Power Supply; Using The Emergency Override Switch; Switching Off The Cooler - wamovo KB35 Instructions Manual

8.6 SETTING THE TEMPERATURE

• Press the "SET" button (fig. 1.2, page 22) 1x.
• Use the "UP +" (fig. 1.4, page 22) and "DOWN –" (fig. 1.3, page 22)
buttons to select the cooling temperature.
• The cooling temperature appears in the display for a few seconds and
will be applied automatically. The display flashes several times and then
the current temperature is displayed again.
8.7 USB PORT FOR EXTERNAL POWER SUPPLY
The USB port allows you to charge small devices like mobile phones or tablets etc.
To use your cooler in combination with any USB devices, simply connect a USB
cable (not included) to your cooler and device.

8.8 USING THE EMERGENCY OVERRIDE SWITCH

The emergency override switch is located at the control panel. For normal operation
the switch is in „normal use" position.
• If an electronic control failure occurs, switch the cooler to „emergency
override" mode.
NOTE!
The cooler will work with full cooling capacity and may freeze when switched to
emergency override mode.

8.9 SWITCHING OFF THE COOLER

• Empty the cooler.
• Switch off the cooler.
• Pull out the connection cable.
If you do not want to use the cooler for a longer period of time:
• Leave the cover slightly open. This prevents odor build-up.
Compressor cooler KB 35 & KB 45
32