Adjustment Instructions - LG 21FS2RLX Service Manual

1. Application Object
These instructions are applied to all of the color TV, MC-049C.
2. Notes
(1) Because this is not a hot chassis, it is not necessary to use
an isolation transformer. However, the use of isolation
transformer will help protect test instrument.
(2) Adjustment must be done in the correct order.But the
adjustment can be changed by consideration of mass
production.
(3) The adjustment must be performed in the circumstance of
25±5°C of temperature and 65±10% of relative humidity if
there is no specific designation.
(4) The input AC voltage of the receiver must keep rating
voltage in adjusting.
(5) The receiver must be operated for about 15 minutes prior
to the adjustment.
3. Focus adjustment
3.1. Preliminary steps
Tune the TV set to receive a digital pattern.
(SVC mode:Automatically mode change the STANDARD
mode)
A
<Fig 1. PAL Digital Pattern(EU05CH)>
3.2. Adjustment Method
1) Single Focus CPT
Adjust the upper Focus volume of FBT for the best focus of
horizontal line A,vertical line B.
4. Screen voltage adjustment
(1) Receive the PAL or SECAM(NTSC) signal into RF mode
regardless of channel.
(2) If you press the "ADJ"button in LINE SVC mode(IN-START
button),the LINE SVC mode changes to screen adjustment
mode.
(3) Adjust the screen volume of FBT jack,When width line is
seen turn the FBT screen volume at the position of
disappearance it.
(4) Press the TV/AV button to exit SVC mode.
All manuals and user guides at all-guides.com

ADJUSTMENT INSTRUCTIONS

B
- 8 -
5. White balance adjustment
NOTE : When adjusting white balance automatically,connect the
adjustment JIG in SVC mode.(When pressing ,MUTE
button on remote control, it changes to CPU OFF MODE
and screen displays "AUTO".)
(1) Receive 100% white pattern.
(2) Adjust LOW Light status(4.5FL) of CUT R, CUT B at CUT
G:80.
(3) Adjust HIGH LIght status(35FL) of WDR R, WDR B at
WDR G:400.
(4) Repeat above step (2) and (3) for the best condition each
status of High Light and Low Light.
<Table 1> White Balance Color analyzer
Menu
X
Y
Color Temperature
9000°K
<Table 2> White Balance Initial Data
Menu Menu
LOW LIGHT CUT R
CUT G
CUT B
HIGH LIGHT WDR R
WDR G
WDR B
<Table 3> White Balance Initial Data
1. IC
Name Maker
VCD IC VCT49xyi Micronas
EP_ROM 24C16 ST, ATMEL
2. White balance IIC Parameter
Program TWBeng_v049 Program
Vcd Slave BCF0 Eprom_Slave
R_Amp
Program TWBeng_v049 TWBeng_v049
Sub Add 1C8
Start Bit 12
Stop Bit 4
Offset 0
Polarity 1
EP_Rom_S 9091
Speed/ Plus 1
EU N-EU
288 266
295 273
13000°K
Range DATA
0 ~ 511 80
0 ~ 511 80
0 ~ 511 80
0 ~ 511 400
0 ~ 511 400
0 ~ 511 400
Algorithm
0 A 0
TWBeng_v049 Speed
AC 1
R_Cut B_Amp B_Cut
TWBeng_v049 TWBeng_v049
1C3 1CA 1C5
12 12
4 4
0 0
1 1
8A8B 9495 8E8F
1 1
Delay
30
12
4
0
1
1