Advertisement
Available languages
Available languages
Troubleshooting
LCD screen turns on
but appliance doesn't
respond to controls.
All control panel lights
flash and Overload
Protection displayed
on LCD screen
BLENDING
Food is unevenly
chopped
Food is chopped too
fine or is watery
•
The safety locking arm may not be correctly engaged in the vertical operating
position. In this case, the LCD screen will show an animated prompt
Check the top cover is properly aligned and the locking arm is located firmly
into the two grooves on either side of the juicer cover or blender jug.
•
This indicates motor overload protection is activated due to motor
overheating or stalling.
•
To reset the protector, unplug from the power supply, then plug back in and
turn on.
•
If Overload Protection is still displayed, unplug the appliance and leave to
cool for at least 30 minutes, then try again. The appliance must be unplugged
while cooling in order to reset properly.
•
If the issue persists after allowing to cool, this indicates an internal problem.
Please call Breville Customer Service or your nearest Authorized Breville
Service Center.
•
Note that triggering the overload protection indicates abnormal use of
the appliance, such as too much load in the blender jug, excessive push
force when juicing or extended continuous use. Please take note of the
conditions and refer to all of the information in these instructions to avoid this
occurrence and extend the life of the appliance.
•
This can happen when too much food is being added at one time.
Try a smaller amount, and work in batches if necessary.
•
Try blending for shorter period of time. Use the PULSE function for
better control.
.
15
Advertisement
