Polaris RZR XP 1000 EPS Owner's Manual page 91

Engine Oil
Oil and Filter Change
6. Lubricate the o-ring on the new filter with a film of fresh engine oil.
Check to make sure the o-ring is in good condition.
7. Install the new filter and turn by hand until the filter gasket contacts
the sealing surface, then turn an additional 1/2 turn.
8. Reinstall the crankcase drain plug with a new sealing washer.
Torque to 12 ft. lbs. (16 Nm).
NOTE: The sealing surface on the drain plug should be clean and free of burrs,
nicks or scratches.
9. Remove the oil fill cap and add 2.5 quarts (2.4 l) of recommended
oil. Reinstall the fill cap.
10. Start the engine and allow it to idle for 30 seconds.
11. Stop the engine. Wait 15 seconds before removing the dipstick.
12. Remove the dipstick. Wipe it dry with a clean cloth.
13. Reinstall the dipstick completely. Remove the dipstick and check
the oil level.
14. Remove the oil fill cap to add the recommended oil as needed.
Maintain the oil level between the minimum and maximum marks
on the dipstick. Do not overfill.
15. Reinstall the fill cap.
16. Reinstall the dipstick.
17. Dispose of used filter and oil properly.
MAINTENANCE
89