Table of Contents
Advertisement
Winter Storage
The machine should be readied for storage at the
end of the mowing season (or if it will not be used
for longer than 30 days). Fuel allowed to stand for
long periods of time (30 days or more) can leave
sticky residues that can plug the carburetor and
disrupt engine function.
Fuel stabilizers are an acceptable option as regards
to the sticky residues that can occur during storage.
Add stabilizer to the fuel in the tank or in the storage
container. Always use the mixing ratios specified by
the manufacturer of the stabilizer. Run the engine for
at least 10 minutes after adding the stabilizer so that
it reaches the carburetor. Do not empty the fuel tank
and the carburetor if you have added stabilizer.
WARNING!
Never store an engine with fuel
in the tank indoors or in poorly
ventilated spaces where fuel vapor
can come in contact with open
flames, sparks, or a pilot light
such as in a boiler, hot water tank,
clothes drier, etc. Handle the fuel
with care. It is very flammable and
can cause serious personal injury
and property damage. Drain the fuel
into an approved container outdoors
and store far away from open flame.
Never use gasoline for cleaning. Use
a degreaser and warm water instead.
stoRAGe
To ready the machine for storage, follow these
steps:
1. Thoroughly clean the machine, especially under
the mower deck. Touch up damage to the paint
and spray a thin layer of oil on the underside of
the mower deck to avoid corrosion.
2. Inspect the machine for worn or damaged parts
and tighten any nuts or screws that may have
become loose.
3. Change the engine oil; dispose of properly.
4. Empty the fuel tanks or add a fuel stabilizer.
Start the engine and allow it to run until the
carburetor is drained of fuel or the stabilizer has
reached the carburetor.
5. Remove the spark plug and pour about a
tablespoon of engine oil into the cylinder.
Turn over the engine so that the oil is evenly
distributed and then refit the spark plug.
6. Lubricate all grease zerks, joints, and axles.
7. Remove the battery. Clean, charge, and store
the battery in a cool place, but protect it from
direct cold.
8. Store the machine in a clean, dry place and
cover it for extra protection.
Service
When ordering spare parts, please specify the
purchase year, model, type, and serial number.
Always use genuine Husqvarna spare parts.
An annual checkup at an authorized service
workshop is a good way to ensure that the machine
performs its best the following season.
45
Husqvarna-
Advertisement
Table of Contents
