Advertisement
Installation
1
Mounting the Spring Tine
Toolbar to the Mid-Mount
Toolbar System
Parts needed for this procedure:
1
Spring tine toolbar assembly
2
Saddle bracket
2
Guard
4
Bolt
4
Nut
1
Extension spring
1
Pivot bracket (not loose on all assemblies)
1
Bolt (3/8 x 2-3/4 inches) (not loose on all assemblies)
Procedure
1. Loosen the nut securing the mid-mount pivot tube
extension spring rod to the spring bracket (refer to
the Mid-mount Toolbar System Installation Instructions)
until the spring is not under tension. Do not remove
the nut, just loosen.
2. Remove the 2 bolts and nuts securing a pivot tube
bracket to the frame (Figure 1). Remove the pivot
tube bracket from the pivot tube.
1. Locknut
2. Pivot tube bracket
3. Bolt
Figure 1
4. Pivot tube
5. Extension spring
6. Spring rod
3. Replace the pivot tube bracket with a saddle bracket
and secure it to the frame with the bolts and nuts
previously removed (Figure 2).
4. Repeat steps 2 through 3 for the other end of the
pivot tube.
5. Mount a guard to the outside of each saddle bracket
with 2 bolts and nuts (Figure 2). Position the guards
so that the decals face up.
6. Hook the short end of the extension spring (included
in kit) to the tab on the pivot tube (Figure 2).
7. If the pivot bracket and bolt (3/8 x 2-3/4 inches)
are not installed, install them on the left side of the
toolbar between the fourth and fifth set of tines
(Figure 2).
2
Advertisement
