Table of Contents
Advertisement
Initial installation
Setting options for DVB-S reception (continued):
Test reception
INITIAL INSTALLATION
The ratio of signal (Carrier) to noise (Noise) (C/N) shows you the quality of the
received DVB signal. The greater the value the better.
Astra1 19,2°E
The signal level tells you how strong the DVB reception is.
Proceed
OK
After you have made the previous settings, you should
receive picture and sound of the selected satellites (only
possible for Astra1 and HOTBIRD).
OK Proceed.
Settings
INITIAL INSTALLATION (ASTRA1 19,2°E)
Scrambled stations
Search method
Symbol rate 1 (DVB-S)
Symbol rate 2 (DVB-S)
Proceed
OK
Select and adapt settings.
If several satellites are received, the following settings
must be made for every satellite. The scope of the settings
may differ depending on the selected satellite.
Encrypted
You can state whether coded stations are to be searched
stations
for in the search/update.
scrambled stations.
received in connection with a CA module and the appro-
priate Smart Card. Handling of the CA module is described
on page 55.
If a CA module with a SmartCard is already plugged in for
the station search, all the stations which this module can
descramble are also saved when no is preset.
Search
If you want to run the station search independently of
method
the channel grid, select frequency search for the search
method.
The symbol rates are specified by the satellite provider
Symbol rates
and do not normally need to be changed.
OK Proceed.
- 28
C/N
Level
Back
yes
no
OK
Channel search
27500
22000
Back
Select
yes
to save all found
However, these stations can only be
Setting options for all types of reception:
Favoured
INITIAL INSTALLATION
signal source
Favoured signal source
DVB-T
DVB-C
ASTRA1 19,2°E
Antenna/cable (analogue)
Proceed
OK
Select favoured signal source.
Select the signal source from a list, the station of
which is to be at the top of your station list (starting
with station slot 1).
The listed signal sources depend on the selected
antennas and, if the set is equipped with a satellite
tuner, the type of satellite system used and the
received satellites.
OK Proceed.
Logical
INITIAL INSTALLATION
Channel
Logical Channel Number
Accept Logical Channel Number
Number
Proceed
OK
Accept Logical Channel Number no / yes.
In some countries, digital channels (DVB-T, DVB-C,
DVB-S) are transmitted with a prescribed programme
number per channel; these are known as "Logical
Channel Numbers" – "LCN".
If you select yes here, these prescribed channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. Depending on the
LCN, spaces or double channel allocations can occur
in the numbering of the channel list.
OK Proceed.
OK
Back
no
yes
OK
Back
Advertisement
Table of Contents
