Advertisement

Quick Links

®
DEL Ozone ABG 25
INSTALLATION INSTRUCTIONS
& PRODUCT MANUAL
C-M-P.COM/DEL
4-2353-01 Rev.B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DEL Ozone ABG 25 and is the answer not in the manual?

Questions and answers

Summary of Contents for CMP DEL Ozone ABG 25

  • Page 1 ® DEL Ozone ABG 25 INSTALLATION INSTRUCTIONS & PRODUCT MANUAL C-M-P.COM/DEL 4-2353-01 Rev.B...
  • Page 2 IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS. • Read this manual completely before attempting installation. • All permanent electrical connections should be made by a qualified electrician. • Connect to a grounding type receptacle only. If the ozone generator electrical connection is to be attached to the pool controls, be sure the pool controls are protected by a Ground Fault Circuit Interrupter (G.F.C.I.).
  • Page 3: Table Of Contents

    TABLE OF CONTENTS SECTION 1 General Information 1A. Description ................1 1B. Specifications ................1 SECTION 2 Installation 2A. Location ..................2 2B. Wall Mounting ................ 2 2C. Electrical ..................3 2D. Plumbing ..................3 SECTION 3 Operation 3A. General ..................5 3B.
  • Page 4: Section 1 General Information

    SECTION 1 General Information 1A. Description The DEL Ozone ABG 25 (Part numbers EC-AG1U and EC-AG2U) described in this manual is designed to provide the benefits of ozonated water in an environmentally safe and effective manner. The high quality, specially engineered components ensure efficient ozone output and reliable performance.
  • Page 5: Section 2 Installation

    SECTION 2 Installation Figure 1: Wall Mount 2A. Location The Ozone Generator units are designed for wall mounting. See Figure 1. Mount in a clean, protected area, either indoors or outdoors (preferably out of direct sunlight). Locate out of reach of sprinklers or drainage spouts.
  • Page 6: Electrical

    SECTION 2 Installation 2C. Electrical 2C-1. Main Power Connect the Ozone Generator to the pool timing clock so that the Ozone Generator operates simultaneously with the pool pump. The circuit must be protected by a ground-fault circuit interrupter (GFCI) installed in accordance to electrical code. Refer to the IMPORTANT SAFETY INSTRUCTIONS at the beginning of this manual for important wiring information.
  • Page 7 SECTION 2 Installation...
  • Page 8: Section 3 Operation

    If the Ozone Generator is mounted above the water line attach the other end of the Ozone Supply Tubing to the ozone out fitting on the DEL Ozone ABG 25 and secure with the supplied hose clamps. If the Ozone Generator is mounted below the water line, the Ozone Supply Tubing must be run to a point above the water line.
  • Page 9: System Shut-Down

    SECTION 3 & 4 | Operation & Maintenance 3C. System Shut-Down If the system is to be shut down for an extended period disconnect the Ozone Generator power cord and disconnect the Ozone Supply Tubing from the Ozone Generator. 4A. System Electromechanical Overview 4A-1.
  • Page 10: Ozone Generator Servicing

    SECTION 4 Maintenance & Service 4B-4. While operating, check regularly to see if bubbles are entering the pool. (If you have installed an MDV, check the MDV for bubbles.) 4B-5. Regularly inspect Ozone Supply Tubing for cracks or wear. Also check to make sure no water is present between the Check Valve and the Ozone Generator.
  • Page 11 SECTION 4 Maintenance & Service Figure 3: Cover Screw and Tabs LIFT COVER UP Figure 4: Lifting Cover SLIDE COVER OFF Figure 5: Sliding Cover Off...
  • Page 12 SECTION 4 Maintenance & Service 4C-3. Ozone Module Replacement 1. Open the Ozone Generator as described in SECTION 4C-2. 2. Remove the Mounting Hardware. 3. Disconnect power supply connector (red & black wires). 4. Lift Ozone Cells, Grommet, Hose Barb Fitting, and Ozone Tubing up and out from the Base Plate.
  • Page 13: Troubleshooting

    SECTION 4 Maintenance & Service 4D. Troubleshooting Knowledge of electrical applications is required for trouble shooting. Contact a certified electrician if you are unsure of your ability to service the equipment. Improper servicing will void the Warranty. Symptom: No Flow. 1.
  • Page 14 NOTES...
  • Page 15 NOTES...
  • Page 16 CMP , LLC 36 HERRING ROAD, NEWNAN, GA 30265 WWW.C-M-P .COM/DEL 0118lm...

This manual is also suitable for:

Ec-ag1uEc-ag2u

Table of Contents