Advertisement
FOR
INSTRUCTION MANUAL: SLAP CAR
8+
AGES
SETTING UP SLAP CAR
1. Turn off the power switch.
2. Use a phillips screwdriver to
open the battery cover.
3. Connect the battery wire to the
Slap Car's connector as shown on
the diagram.
4. Close the battery compartment,
reinstall the screw, and switch the
power switch to On.
Battery Connector
1
Advertisement
Table of Contents
Related Manuals for Odyssey Toys SLAP CAR
Summary of Contents for Odyssey Toys SLAP CAR
- Page 1 1. Turn off the power switch. 2. Use a phillips screwdriver to open the battery cover. 3. Connect the battery wire to the Slap Car’s connector as shown on the diagram. 4. Close the battery compartment, reinstall the screw, and switch the power switch to On.
- Page 2 Tip. Full charge takes approx. 1hr OPERATING SLAP CAR - For best results the Slap Car needs to be within a 15’ foot range of the controller. Controller Functions...
- Page 3 Reverse & Turn Left Reverse & Turn Right Slap Car Programming To program your slap car, press the middle programming button, followed by the direction buttons you want to program eg. When you have finished press again to run the program.
- Page 4 • Keep hair and loose clothing away from the Slap Car when powered on. • If Slap Car will be stored and unused for an extended period of time, please remove the batteries. • Check the batteries regularly for potential leakage or corrosion that may occur.
Need help?
Do you have a question about the SLAP CAR and is the answer not in the manual?
Questions and answers