Maxwell MW-3547 W - Desk Fan Manual

Table of Contents

Contents

1 DESCRIPTION
2 BEFORE THE FIRST USE
3 ASSEMBLING
4 USAGE
5 OSCILLATION AND TILT FUNCTION
6 MAINTENANCE AND CARE
7 DELIVERY SET
8 TECHNICAL SPECIFICATIONS
9 Documents / Resources
- 9.1 Download manual

DESCRIPTION

The fan is intended for artificial ventilation of the room.

DESCRIPTION

Front grid
Blades
Rear grid with clamps
Rear grid fastening nut
Oscillation On/Off button
Motor unit
Hinged joint (slope angle adjustment)
Power cord
Stand
Control panel

BEFORE THE FIRST USE

After unit transportation or storage at low temperature keep it for at least three hours at room temperature before switching on.

ASSEMBLING

Unpack the unit and remove any stickers that can prevent its operation.
Check the unit for damages, do not use it in case of damages.
Do not switch the fan on until it is completely assembled.
Place the stand (9) of the fan on a dry, flat and steady surface.
Set the rear grid (3) on the motor unit (6) and fix it with the nut (4).
Put the blades (2) on the motor axis.
Open the clamps on the rear grid (3).
Install the front grid (1) on the rear grid (3) and close the clamps.
The fan is ready for operation.

USAGE

Before using the unit for the first time, make sure that the voltage in your mains corresponds to operating voltage of the fan.

Place the fan on a flat, dry and steady surface.
Insert the power plug (8) into the mains socket.
Select the required operation mode of the fan by pressing buttons on the control panel (10):
"0" – Fan is switched off.
"1" – Low air flow speed.
"2" – High air flow speed.
After the unit operation switch the fan off by pressing the "0" button on the control panel (10) and unplug the unit.

OSCILLATION AND TILT FUNCTION

Press the button (5) to switch the 90° oscillation operating mode of the fan on. Lift the button (5) by pulling it upwards to switch the oscillation mode off.
To change the fan slope angle take the motor unit (6) and tilt it at the required angle. Clicking is normal in that case.

MAINTENANCE AND CARE

Before cleaning the fan set the operation mode switch (10) to the "0" position and unplug the unit.
Do not immerse the fan, power cord and power plug into water or any other liquids.
Make sure that no liquids get into the motor unit (6) of the fan to avoid its damage and prevent risk of electric shock.
Do not use abrasive cleaners and solvents to clean the unit.
Clean the motor unit of the fan with a soft and slightly damp cloth, then wipe it dry.
If you need to clean the blades (2) and grids (1, 3):
- lift the clamps on the rear grid (3) and remove the front grid (1);
- remove the blades (2);
- unscrew the nut (4) and remove the rear grid (3)
Clean the grids (1, 3), blades (2) with a slightly damp cloth, then wipe it dry.
Assemble the fan in reverse order.
Keep the fan in a dry cool place.