Echo CS-2511TES Service Manual page 57

CS-2511TES
251Ts, 251TCs
7-5 Cleaning and replacing auto-oiler assembly (continued)
E
L
A
B
SAW CHAIN LUBRICATION SYSTEM
K
J
k2
K
U
P
D
C
26. Push in plunger gear (E) with small screw-
driver, and hold plunger gear (E) to direction of
arrow with finger. Remove screwdriver.
27. Install adjuster needle (K) with spring (L) into
oiler body. Release finger from plunger gear (E).
28. Press adjuster needle (K) to the bottom, orient-
ing the flat surface (k1) as shown. This position
indicates maximum discharge volume of chain oil.
29. Tap new spring pin (J) into hole (k2) of adjuster
needle (K).
30. Apply grease in plunger hole (U). Tap plug (P)
into hole (U) with plastic mallet until plug (P) is
flush with end face of oiler body.
31. Connect auto-oiler assembly (B) to oil line (C)
and (D), as shown.
32. Tighten two bolts (A).
33. Reassemble removed parts.
55
k1