Advertisement
Here are the tools you'll need to
complete your installation:
Ladder
Screwdriver
Pliers
OPTIONAL
If mounting to a support structure, you will also need
these tools.
Drill
9/64" Drill Bit
OPTION 1: Machine Screws
1
Use machine screws (provided
with outlet box) and washers
when securing to existing ceiling
fan-rated outlet box. Make sure
it is securely installed and is
bag
acceptable for fan support of
31.8 kg (70 lbs) or less.
For installing the hanger bracket and wiring the fan
x5
For installing the blades
Quick Install Guide
30 inches
from blade tip to
nearest wall or
obstruction
Wire Strippers
OFF
Assembly Instructions
OPTION 2: Wood Screws
Use wood screws and washers
(included) when securing to support
structure with approved electrical
outlet box. Drill 9/64" pilot holes in
support structure to aid in securing
ceiling bracket with hardware found
in the
hardware bag.
x2
8
x15
bag
NOTICE
7
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
x15
bag
You will find these screws in
the motor's shipping blocks.
7 feet
from bottom
edge of blade to
the floor
WARNING
To avoid possible electrical shock, before
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
x4
x2
Place the downrod ball into
4
the slot in the ceiling bracket.
5
See back
for wiring
9
Connect the fan pull chain pendant to the
13
short chain coming from the switch housing.
You must
be able to
secure the
fan to building
structure or
fan-rated
outlet box.
Remove the
shipping blocks
from the motor.
Save the screws.
They will be
needed for blade
iron installation.
1
3
bag
For installing the canopy
6
WARNING
2
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
10
x3
11
x3
Install a bulb into each
12
x3
of the sockets. When
necessary, replace with
bulbs of the same type
and wattage.
x3
For installing the light kit
M3779-01 r121119 © 2019 Hunter Fan Company
x2
bag
Advertisement
