Table of Contents
Advertisement
TELESCOPIC SLIDING SHELF SUPPORTS (SOME MODELS ONLY)
The telescopic sliding shelf supports make it safer and easier to insert and remove the
oven shelves and trays. They stop when they are pulled out to the maximum position.
Important! When fitting the sliding shelf supports, make sure that you fit:
■
The slides to the top wire of a rack. They do not fit on the lower wire.
■
The slides so that they run out towards the oven door.
■
Both sides of each pair of shelf slides.
■
Both sides on the same level.
To fix the sliding shelf supports onto the side racks:
■
Screw the side racks onto the oven wall. (fig. 10).
■
Fit the sliding shelf supports onto the top wire of a rack and press (fig. 15). You will
hear a click as the safety locks clip over the wire.
To remove the telescopic sliding shelf supports:
■
Remove the side racks by unscrewing the fixing screws (fig. 10).
■
Lay down the telescopic sliding shelf support and side racks, with the telescopic sliding
shelf support underneath.
■
Find the safety locks. These are the tabs that clip over the wire of the side rack (arrow
1 in fig. 16).
■
Pull the safety locks away from the wire to release the wire (arrow 2 in fig. 16).
Cleaning the sliding shelf supports:
■
Wipe the supports with a damp cloth and a mild detergent only.
■
Do not wash them in the dishwasher, immerse them in soapy water, or use oven
cleaner on them.
Figure 15
Figure 16
1
2
1
17
17
Advertisement
Table of Contents
