Table of Contents
Advertisement
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first press the power
switch and unplug the power adapter. Next, remove
the three indicated M4 x 14mm Screws (17) from the
Right and Left Shields (30, 32).
Then, carefully pull the tops of the Right and Left
Shields (30, 32) apart a few inches.
See the inset drawing. Slightly loosen the two indi-
cated #8 x 1/2" Screws (57). Next, rotate the Left
Crank Arm (21) until a Pulley Magnet (137) is aligned
with the Reed Switch (115). Slide the Reed Switch
slightly toward or away from the Pulley Magnet. Then,
retighten the Screws.
Plug in the power adapter, press the power switch,
and rotate the Left Crank Arm (21) for a moment.
Repeat these actions until the console displays correct
feedback.
When the reed switch is correctly adjusted, reattach
the Right and Left Shields (30, 32).
115
115
57
83
21
31
17
21
17
137
17
30
32
Advertisement
Table of Contents
