Keys And Functions - Philips SRU 3030/10 Instructions For Use Manual

Instructions for use
Automatically setting the remote control
The remote control will now automatically search for the right code for your
device.
Example of TV:
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
• If the device is a DVD-player/recorder or video recorder, insert a disk or
tape and start playback.
2
Select TV: keep the TV key pressed for
5 seconds until it blinks twice and then
remains lit.
3
Press the Standby key of the SRU 3030
and keep it pressed.
– The SRU 3030 now starts emitting all known
'TV off ' signals, one by one.
Each time a code is sent, the TV key lights up.
4
When your TV switches off (stand-by), immediately release the Standby
key of the SRU 3030.
– The SRU 3030 has now found a code that works on your TV.
5
Check if you can operate all functions on your TV with the SRU 3030.
• If this is not the case, you can redo the automatic setting.
The SRU 3030 will then search for a code that works better.
– After the SRU 3030 has run through all the known codes, the search
will stop automatically and the TV key stops blinking.
– Automatic programming of a TV takes a maximum of 6 minutes.
For DVD and VCR this time is 2 minutes.

3. Keys and functions

The illustration on page 3 gives an overview of all keys and their functions.
1 y Standby. . . . . . . . . switches TV,VCR or DVD on or off.
2 Easy brand scan. . . switches between normal operation mode and
3 MENU /
6
Easy brand scan mode (press with pen or
paperclip). Also see 'Quick Start Guide'.
. . . . . . . DVD:
- switches the disc menu on and off.
- pressed together with SHIFT 6: enters the
system menu.
TV:
- switches teletext on/off.
- pressed together with SHIFT 6: opens the TV
menu.