NORBIT AQUA FCL600 Quick Manual

QUICK GUIDE FOR INSTALLATION OF NORBIT AQUA
FCL600 UNDERWATER LIGHTS
December 2022
This guide covers the required steps to mount and start NORBIT's underwater light, the FCL600. For
detailed instructions and technical specifications, refer to the FCL600 manual and product sheet at
norbit.com/aqua/products-solutions/
Delivery contents (may vary)
1. A standard pallet contains lights andcontrol cabinets and must contain the following:
4 control cabinets with 2x5 meter cable, hereafter referred to as PDC (Power Distribution
•
Cabinet)
8 FCL600 underwater lights with 30-meter cable
•
4 power plugs for connection to the 220V input on the PDC
•
8 blue velcro straps for fastening the PDC
•
4 eyebolts with disc and nut for screwing into each PDC, as secondary security
•
Preparations before mounting on the pen.
Before bringing the light and PDC out to the pens (sites), it is recommended to review this guide and ensure
the equipment is prepared for setup and installation. A recommended light setup when using the NORBIT
FCL600 is typically 4 lights in each pen (assuming 157 meters in circumference) that are powered and
controlled from the two PDCs. Each PDC operates a pair of lights (Figure 1). Typically, the PDCs sit directly
opposite each other in the pen. (Figure 2)
Figure 1. One PDC controls two 600-watt lights
It is recommended to measure the distance from the electrical cabinet on the pen to the PDCs and then
adapt the length of the power cable based on this measurement. Both cables should then be fitted using the
supplied power connectors. The current-carrying wires are connected to socket nr 1 and 2 in the connector
and ground cable to the socket marked with the
The delivery includes stainless eyebolts which will act as secondary protection. Primarily, to prevent the
PDC from moving horizontally on the handrail and to reduce pendulum movement that can occur in stormy
Figure 2. Standard setup on a 157-meter pen
symbol.
https://
NORBIT AQUA FCL600