IKEA SKYTTA Installation Manual page 9

Door assembly
The door has two symmetrical side rails, bottom rail and top rail, marked with tape.
The wheel fitting is placed in the bottom and the guide fitting in the top. Click in the
horizontal bars on the side rails and spread them out so they match the height just
above the door filler panels. The guide pins with wings should be placed to match the
activator between doors.
DRAFT DRAFT DRAFT
Door fillers
The door filler panels are centred between the door side rails. Make sure that the panel
is inside the gasket flange. Never leave the panel without mounting the horizontal bar
or the top lid closed for the top panel. The plastic pin in the bar clicks in is to secure
that it can't be released.
Adjust door/activate soft close
By adjusting the wheel fitting's height, you can adjust the gap between the doors and
the door/wall. Release the two screws and turn the adjustment between the screws.
You have +/-2 mm (1/8") on each wheel.
The soft closing is activated by moving the door all the way to the wall. You will hear a
click, and after that the soft closing should work.
Top cover
The top cover is the same front and back and is clicked on the ceiling rail on both sides.
If you are connecting two top rails, make sure the cut end is towards the wall.
Mount door/clean floor rail
Clean the floor rail before mounting as dust can get stuck on the wheels. This should
be done regularly to maintain a nice sliding of the doors. Follow the layout with the
activator/soft closing. The guide pins with wings should be connected to the activator/
soft closing between doors.
1
2x
2
Door handle
The door handle clicks into the door side rail. To get it into the correct position, the cut
out on the handle should match the plastic clip mounted on the backside of the middle
bar. This prevents the handle from moving vertically and makes all handles match in
height.
Home position middle doors
When a door has its closed position in the middle of the solution and not to a wall, you
mount the home position. The home position works together with the door guide and
activator. The home position has a wing nut that grips into the aluminum track during
assembly. Adjust by releasing the screw, slide to new position and tighten the screw.
2x
9