Q&A - Samsung WA3000J Service Manual

4-5. Q&A
Q. What should I do when Information
Code ("HOT LED") flash?
Q. There is a small amount of water
left in Detergent Drawer after the
load is complete. Is this normal?
Q. W hen I went back to my washer, it
was turned off. What happened?
28 _ Troubleshooting
A. When the Information Code is displayed, press the Start/Pause dial and
then restart the cycle. For more information, refer to the Owner's Manual.
A. It is normal for a small amount of water remaining in Detergent Drawer
after it completes washing. Also, its compartment is washed again during
the following rinse cycle, removing any remnants.
A. Power button may have been accidentally bumped or pushed. Reset
the cycle and start the washer. Make sure the unit is plugged into a live
electrical outlet. Check house fuse or circuit breaker.